Appendix C Configuring the Switch with the
Completing the Setup Program
Step 9 Enter Y to configure the switch as the cluster command switch. Enter N to configure it as a member switch or as a standalone switch.
If you enter N, the switch appears as a candidate switch in the Network Assistant GUI. You can later configure the switch as a command switch through the CLI or Network Assistant interface. To configure it later, enter no.
Would you like to enable as a cluster command switch? [yes/no]: no
You have now completed the initial configuration of the switch and the switch displays its initial configuration. This is an example of that output:
The following configuration command script was created: hostname host_name
enable secret 5 $1$Max7$Qgr9eXBhtcBJw3KK7bc850 enable password my
line vty 0 15 password my_password
!
no ip routing
!
interface Vlan1 no shutdown
ip address 172.20.139.145 255.255.255.224
!
interface Vlan2 shutdown
no ip address
!
interface FastEthernet0/1
!
interface FastEthernet0/2
!
...<output abbreviated>
!!!
interface GigabitEthernet0/1
!
end
Step 10 These choices appear:
[0]Go to the IOS command prompt without saving this config.
[1]Return back to the setup without saving this config.
[2]Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, save it in nonvolatile RAM (NVRAM) by selecting option 2.
Enter your selection [2]:2
Make your selection, and press Return.
Catalyst 2940 Switch Hardware Installation Guide
| ||
|
