OPERATING HEATER
Continued
MANUAL LIGHTING
PROCEDURE
1.Follow steps 1 through 6 under Lighting Instructions, page 16.
2.Depress control knob and light pilot with match.
3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow steps 9 through 11, Lighting Instructions, page 17.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must be purchased separately (see Accessories, page
26). Follow instructions included with the remote control.
NOTICE: You must light the pilot before using the
After lighting, let pilot flame burn for about one minute. Turn control knob to ON posi- tion. Adjust flame adjustment knob anywhere between HI and LO. Slide the selector switch to the REMOTE position (see Figure 19). Note: The burner may light if
IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.
Control | Piezo | Selector Switch in | |
Ignitor | |||
Knob | |||
REMOTE Position | |||
| |||
|
| ||
|
| REMOTE | |
|
| OFF | |
|
| ON | |
Flame Adjustment |
| ||
Knob |
|
|
Figure 19 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
ON/OFF SERIES (MODEL GHRCB)
Hold the control button on the
Control Button
Turns Burners
On and Off
Figure 20 - On/Off
THERMOSTAT SERIES (MODEL GHRCTB)
The
Manual Mode
1.Press the POWER and LOCK buttons together to turn on the
2.Press the MANU button to turn on the fireplace.
3.Press the POWER and LOCK buttons together to turn off the fireplace.
Auto (Thermostatic) Mode
1.Press the POWER and LOCK buttons together to turn on the
2.Press AUTO button to select this mode.
3.Set the desired room temperature by press- ing the TEMP + or - buttons.
4.Press the POWER and LOCK buttons together to turn off the fireplace.
18 | www.desatech.com |