How to change the storage/disk manager features (continued)

Stamp creation/deletion (continued)

How to create a stamp (continued)

Procedure:

First set of measurements:

The first step is the stamp pattern design. The stamp pattern shown to the left has a scanned image (the X), and date (9.16.95), and numbering (PRELIMINARY).

Once the stamp has been designed, it is necessary to make several sets of measurements. These measurements are entered on the stamp create/store screen (custom presets). These sets of measurements are used by the scanner to create the stamp.

Note: If you are going to include the date stamp and or the numbering stamp, ensure to include enough room for these features.

The first set of measurements tells the scanner where to begin scanning. These measurements are called the start position X and Y coordinates.

X1 Distance from the left edge of the paper to the left edge of the stamp pattern.

Y1 Distance from the top edge of the paper to the top edge of the stamp pattern.

Second set of measurements:

The second set of measurements tells the scanner height and width of the stamp pattern. These measurements are called the end position X and Y coordinates.

X2 The width of the stamp pattern.

Y2 The height of the stamp pattern.

How to customize the MAX 200

235

Page 237
Image 237
Xerox MAX 200 manual Procedure First set of measurements, Second set of measurements