Xerox MAX 200 manual Scanner document feed panel, Power save button

Scanner control panel (continued)

Power save button

Note: For detailed information on how to setup power save, in custom presets, refer to page 178.

Introduction

The power save function reduces machine power consumption when the machine is not used for a selected period of time.

When the machine enters the power save mode, current to the fuser is reduced, and the electrical control signals (except auto mode panel and scanner control panel) are switched off.

The power save feature in custom presets, can be set from 1 to 30 minutes, or the feature can be disabled entirely by entering No minutes. The factory default is set to No minutes.

The interval timer clock is reset whenever the power save button is pressed and the machine is currently in the power save mode.

If the machine is in power save mode and you would like to begin making copies, press the power save button. Once the machine completes the warm-up cycle and the ready to copy message is displayed, you may begin coping again.

Procedure

1.Press the power save button.

The power save indicator lamp is lit.

The machine enters the power save mode.

2.To exit the power save mode, press the power save button.

Scanner document feed panel

The scanner document feed panel, located below the scanner control panel, displays the document feed direction.

When the ready message is displayed, you can begin scanning your documents.

28 Getting to know the MAX 200