Philips DVDR3570H58 Troubleshooting, Problem General Solution, No power, Remote control does not

Troubleshooting

WARNING!

Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock.

If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to solve a problem by following these hints, consult your dealer or Philips for help.

Problem (General)		Solution
No power.	–	Press the STANDBY-ON button on the front of the unit
		to turn on the power.
	–	Make sure the mains cord is properly connected and the
		AC outlet has power.

English

The message ‘IS TV ON?’ appears on the display panel.

The buttons on the recorder do not work.

–This recorder will not operate until you complete the first installation. See ‘Step 3: Installation and Set-up’ for details.

–There is a technical problem. Disconnect the recorder from the power outlet for 30 seconds, then connect again. If the recorder still will not operate, then reset it to the default factory settings :

1)Disconnect the recorder from the power outlet.

2)Press and hold down STANDBY-ON button on the front of the recorder while reconnecting to the power outlet.

3)Release STANDBY-ON button when ‘STARTING’ appears on the display.

4)Wait until the recorder’s demo start scrolling on the display, press STANDBY-ON again to turn on the recorder. All the information stored in the memory (programmes, time) will be cleared. The initial installation menu will be displayed on the TV.

Remote control does not	–	Aim the remote control directly at the sensor on the
work.		front of this recorder (not towards TV).
	–	Remove any obstacles between recorder and the remote
		control.
	–	Batteries are weak, replace the batteries.

91 91