Xerox MAX 200 manual Folder setup, Folder terminology

How to change the copy features (continued)

Folder setup

Note: If your system is set up with a folder, do not put A or A4 size media into the tray 5, short edge feed. Refer to your user guide for detailed information.

Introduction

The MAX 200 folder setup feature, sets up the MAX 200 fold parameters for three folds assigned to P1, P2 and P3. For detailed information on the type of folds refer to the section, Folder terminology.

Once the MAX 200 program fold parameters are setup, you can program the fold default for copy mode and plot mode. To go directly to the folder setup procedure go to page 205.

•To setup the fold default for copy mode, refer to page 159.

•To setup the fold default for plot mode, refer to page 187. To go directly to the folder setup procedure go to page 205.

Folder terminology

Fan fold

Creates packages folded to A-size, panels do not need to be equal size. Binding margins can be added to fan fold.

Cross fold

Creates packages folded to A-size, panels are not equal in size. No binding margin can be added.

Other packet sizes available

Punch, tab, reinforce	Smaller, Bigger	Packet size
Off	Smaller	185 x 297 mm
Off	Standard	190 x 297 mm
Off	Bigger	198 x 297 mm
On	Smaller	198 x 2972 mm
On	Standard	198 x 297 mm or
		210 x 2973 mm
On	Bigger	210 x 297 mm

2Tabs sticks out 12 mm from paper, the full packet is 198+ 12= 210 mm wide.

3The folder can be set to 198 or 210 as the standard size for tabs to be added to.

How to customize the MAX 200 203