Clearing a printer jam (continued)

Indicator lamp 10

When indicator lamp 10 is lit, there is a media jam in the fuser area.

Procedure

1.First complete the procedure for indicator lamp 9, on page 266. If the jam is not cleared, continue to the next step.

2.Open the front door of the printer.

3.Rotate the latch-handle counterclockwise to open the upper area of the printer.

Note: If the open light is off or blinking, the latch handle can not open the upper area of the printer.

4.Lift the upper area of the printer until the stopper is latched.

Warning: The fuser area is extremely hot. Never touch areas other than the handle when clearing a media jam.

5.Rotate the fuser lever counterclockwise and gently pull the fuser out.

Warning: Sharp fuser parts are labeled; use care to avoid touching them.

6.Remove the jammed media in the direction of the arrow. If it is removed from the left side of the fuser, unfused toner could contaminate the next copy.

268

Problem solving

Page 270
Image 270
Xerox MAX 200 manual 268