Xerox MAX 200 manual Stamp creation/deletion How to create a stamp

How to change the storage/disk manager features (continued)

Stamp creation/deletion (continued)

How to create a stamp

Note: If needed, you can setup your start position, for the stamp location, to be the lead edge or trail edge of your document. If needed, refer to page 192.

Introduction

Stamp pattern

Stamp image

Date stamp

Numbering stamp

With the MAX 200, a stamp pattern is created and then stored on a floppy disk. You later program the machine to add the stamp to each copy made.

In this section, you will learn how to setup the location parameters to scan the image, and then store the image. Once the image is stored it is referred to, as the stamp pattern.

The example at the far left corner has combined a scanned image (the X), the date stamp (9.16.95), and the numbering stamp (PRELIMINARY). The dotted line represents the total stamp pattern area.

Each feature can be used by itself, or combined with the other stamp features to meet your design requirements. The procedure to create a stamp is divided into four sets of measurements:

•The first set of measurements defines the starting position of the stamp pattern.

•The second set of measurements sets the stamp pattern width and height.

•The third set of measurements positions the date stamp feature.

•The fourth set of measurements positions the number stamp feature.

234 How to customize the MAX 200