Installation
Continued
6.Add embers to front flat burner. Gently remove embers from the bag using gloves or tweezers.
(This material is a skin irritant. Gloves or tweezers are recommended to prevent skin irritation). Separate pieces of ember material and place over surface of flat burner (see Figure 27). Spread ember material evenly over surface for greatest glowing effect. Do
NOT place ember material anywhere else on the unit. Use only ember material sup- plied with unit. Excessive ember material may produce carbon monoxide or soot.
WARNING: Do not use rock wool or any other ember material not supplied with this unit.
WARNING: Do not operate unit without ember material correctly in place as shown in Figure 27.
7.Place center crossover log (#7) onto pin on log #5 and resting on grate as shown in Figure 28. Log #7 must overlap grate and rest against grate finger. Log must not rest on burner.
8.Add lava rock and small decorative logs around base of heater if desired. DO NOT place rock or additional logs on front burner or on logs. Placing any material on unit other than ember material on front burner may result in production of carbon monoxide or soot. Use lava rock to hide wires from switch/log to control valve. Place switch/log so the switch is easy to access.
Ember
Material Flat Front
Burner
Figure 27 - Placement of Embers
7
Figure 28 - Installing Log #7
Operating Heater
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result causing property damage, per- sonal injury or loss of life.
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service tech- nician or gas supplier. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
www.desatech.com | 19 |
