Operating Heater
Continued
2.The receiver continuously receives signals from the
Key Pad Lock Feature
This feature allows the user to lock/unlock the keypad on the
Inspecting Burners
Check pilot flame pattern and burner flame pat- terns often.
PILOT FLAME PATTERN
Figure 35 shows a correct pilot flame pattern. Figure 36 shows an incorrect pilot flame pattern. The incorrect pilot flame is not touching the thermocouple. This will cause the thermocouple to cool. When the thermocouple cools, the heater will shut down.
If pilot flame pattern is incorrect, as shown in Figure 36
•turn heater off (see To Turn Off Gas to Appli- ance, page 21
•see Troubleshooting, page 25
Note: The pilot flame on natural gas units will have a slight curve, but flame should be blue and have no yellow or orange color.
Pilot Burner
Thermocouple
Figure 35 - Correct Pilot Flame Pattern
Pilot Burner
Thermocouple
Figure 36 - Incorrect Pilot Flame Pattern
Wiring Diagram
To
Thermopile
To AUTO/OFF/ON
Switch or Remote
Receiver
Cleaning and
Maintenance
WARNING: Turn off heater and let cool before cleaning.
CAUTION: You must keep control areas, burners and circulating air passageways of heater clean. Inspect these areas of heater before each use. Have heater inspected yearly by a qualified service person. Heater may need more frequent cleaning due to excessive lint from carpeting, pet hair, bedding material, etc.
WARNING: Failure to keep the primary air opening(s) of the burner(s) clean may result in sooting and property damage.
www.desatech.com | 23 |