Desa VGL450N Operating Fireplace, For Your Safety Read Before Lighting, Lighting Instructions

OWNER’S MANUAL

INSTALLATION

Continued

2.Place log #2 (large front log) in groove on firebox floor in front of burner with log texture facing up and out (see Figure 22).

3.Place lava rock along sides and front of inside of firebox bottom. It is not necessary to use all of the lava rock provided.

NOTICE: Do not put lava rock on burner or under burner. Placing lava rock on burner could cause performance problems.

Figure 22 - Installing Log No. 2

OPERATING

FIREPLACE

FOR YOUR SAFETY

READ BEFORE

LIGHTING

WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result caus- ing property damage, personal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas sup- plier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been un- der water.

LIGHTING

INSTRUCTIONS

1.STOP! Read the safety information, above.

2.Turn wall switch to the OFF position.

3.Turn off all electric power to the ap- pliance.

4.Remove control access panel.

5.Turn gas control knob clockwise Clockwise to the OFF position.

6.Wait five (5) minutes to clear out any gas. If you smell gas, STOP! Follow “B” in the safety information. If you don’t smell gas, go to the next step.

7.Find pilot. Follow metal tube from gas control. The pilot is behind the burner tube.

8.Turn control knob counterclockwise

C-clockwiseto the PILOT position.

9.Push in the knob all the way and hold in. Immediately light the pilot by pressing the red ignitor button. Con- tinue to hold the control knob in for about (1) minute after the pilot is lit. Release button and it will pop back up. Pilot should remain lit. If it goes out, repeat steps 5 through 9.

•If button does not pop up when released, stop and immediately call your service technician or gas supplier.

•If the pilot will not stay lit after sev- eral tries, turn the gas control knob to “OFF” and call your service technician or gas supplier.

10.Turn gas control knob counterclock-

wise C-clockwiseto “ON”. Knob can be turned to “ON” only if the control knob is popped out.

11.Replace control access panel.

12.Turn on all electric power to the ap- pliance.

Position Indicator

				J	ADJ PILOT
				R
TP	TH TPTH		O			IN
		A
			B		ILO
		E			P	T
		R			OFF
		T
		H
		S				ON
				W

Gas Control Knob

Figure 23 - Control Knob in the PILOT position

Continued

105704 9