Desa VGL450N, VGL450P installation manual Gas Supply Testing, Gas Ratings, Installation, Continued

OWNER’S MANUAL

INSTALLATION

Continued

Installing 9-Volt Battery in Hand- Held Remote Control Unit

1.Remove battery cover on back of re- mote control unit.

2.Attach terminal wires to the battery (not included). Place battery into the battery housing. Note: Only use alka- line battery.

3.Replace battery cover onto remote con- trol unit.

Battery

GAS SUPPLY TESTING

Note: This section is intended as a guide for qualified technicians installing gas to this appliance.

Do not connect appliance before pressure testing gas piping. Damage to gas valve may result and an unsafe condition may be caused.

IMPORTANT: The appliance and its indi- vidual shut-off valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psig (3.5 kPa).

The Gas Control Valve is secured to the burner pan assembly underneath the front

A 1/8" NPT plugged tapping is provided on the Gas Control Valve for a test gauge connection immediately upstream of the gas supply connection to the appliance (see Figure 17).

Red Surface Indicates

For Propane Use Only

Gas Shut							Air Shutter
Off Valve
	Coupling
		OFF	PI	W
			L
			O	AH		TH TP TH
	IN		T	S			TP
					T
		ON			R
				ROB	E
Flexible		PILOT ADJ
	Pilot						1/8" NPT
Gas Line
	Adjustment						Plugged
DO NOT
	Cap						Tapping

Cover

Remote

ledge.

KINK

TerminalControl Unit Wires

9-Volt Battery

Battery

Housing

Figure 16 - Installing Battery in Hand- Held Remote Control Unit

Figure 17 - 1/8" Plugged Tapping Location

GAS RATINGS

TYPE OF GAS:	NATURAL	PROPANE/LP
MAX. INPUT
RATING (Btu/hr):	12,000	12,000
MANIFOLD
PRESSURE:	3.5 in. W.C.	10.0 in. W.C.
* MIN. SUPPLY
PRESSURE:	4.5 in. W.C.	7.0 in. W.C.
MAX. SUPPLY
PRESSURE:	10.5 in. W.C.	13.0 in. W.C.

*For the purpose of input adjustment

Continued

105704 7