OWNER’S MANUAL
Continued
Proceed to secure appliance to prepared framing at nailing flanges located at the sides of the appliance as shown in Figure 11.
Nailing
Flanges
Framing
Nails
VENTING INSTALLATION
A 4"
This appliance has been supplied with a 4" dia. starting collar for a snug fit. Slide
Fasten this first section of "B" vent pipe by running a 3/4" long sheet metal screw through outer wall of pipe until secure. (see Figure 12).
The
Check with your
IMPORTANT: Vent pipe MUST NOT ter- minate in an attic space.
Minimum height for complete system (vent termination and appliance) is 12 feet.
Maximum horizontal run of
Figure 11 - Attaching Fireplace to Wall Studs
Secure
Double Wall
Type Vent
(Not Supplied)
Figure 12 - Securing “B” Vent to Starter Collar
105704 | 5 |