Desa VI33NR Desa International, Unvented Natural Gas Fireplace Insert, Installation, Continued

DESA INTERNATIONAL

UNVENTED NATURAL GAS FIREPLACE INSERT

INSTALLATION

Continued

INSTALLING LOGS

CAUTION: Do not remove the warning and instruction labels attached to the heater base as- sembly. These markings contain important warranty information.

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

WARNING: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to High, check to see if flames contact any log. If so, re- position logs according to the log installation instructions in this manual. Flames contacting logs will create soot.

It is very important to install the logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Place one-piece log set on grate to fit as illustrated in Figure 22. Make sure middle section at bottom of log set is seated into "U"-shaped cutout in cen- ter of chassis (see Figure 23).

IMPORTANT: Make sure log does not cover any burner ports.

2.Install fireplace insert screen by slip- ping notches of fireplace insert screen over screws on front of fireplace insert (see Figure 24).

WARNING: You must operate this fireplace insert with the fire- place insert screen in place. Make sure fireplace insert screen is in place before running fireplace insert.

One Piece

Log Set

Middle

Section at

Bottom of

Log Set

Burner

"U"-shaped Cutout

in Chassis

Chassis

Figure 22 - Installing One Piece Log Set

Burner	One Piece Log Set
Ports

Figure 23 - Installing One Piece Log Set (Top View)

Screws for Mounting

Screen

Notches

Figure 24 - Installing Fireplace Insert Screen

For more information, visit www.desatech.com 12 105647