Desa VI33NR Owner’S Manual, Operating Fireplace Insert, Continued, Shutting Off Heater

OWNER’S MANUAL

OPERATING FIREPLACE INSERT

Continued

WARNING: Make sure the selector switch is in the OFF po- sition when you are away from home for long periods of time. Heater will come on automati- cally with selector switch in the ON position.

Pilot Burner	Ignitor
	Electrode

Figure 32 - Pilot

TO TURN OFF GAS

TO APPLIANCE

Shutting Off Heater

1.Turn control knob clockwise to the OFF position.

OPTIONAL REMOTE

OPERATION

Note: All remote control accessories must be purchased separately (see Accessories, page 26). Follow instructions included with the remote control.

Thermostat Control Operation

(Optional GHRCTA Series Only) The thermostat control setting on the remote control unit can be set to any comfort level between WARMER and COOLER. The burners will turn on and off auto- matically to maintain the comfort level you select. The ideal comfort setting will vary by household depending upon the amount of space to be heated, the output of the central heating system, etc.

For wall thermostat operation, follow in- struction supplied with thermostat acces- sory GWMT1. For wall switch operation follow instructions supplied with GWMS2.

NOTICE: You must light the pilot before using the hand-held re- mote control unit. See Lighting Instructions on page 14.

1.After lighting, let pilot flame burn for about one minute. Turn control knob to ON position. Adjust flame adjust- ment knob anywhere between HI and LO. Slide the remote selector switch to the REMOTE position (see Figure 33). Note: The burners may light if hand-held remote ON button was on when remote selector switch was last turned off. You can now turn the burners on and off with the hand- held remote control unit.

IMPORTANT: Do not leave the re- mote selector switch in the RE- MOTE position when the pilot is not lit. This will drain the battery.

IMPORTANT: Be sure to press the ON/OFF buttons on the hand-held remote control unit for up to 3 sec- onds to assure proper operation.

GHRC Series Operation:

2a. Press the ON/OFF button to turn the burner on and off. When turning burner off, the pilot will remain lit.

2a. Set selector switch in the OFF position.

2b. If Using Optional Hand-Held Re- mote: Set remote selector switch in the OFF position to keep from drain- ing battery.

Shutting Off Burners Only (pilot stays lit)

You may shut off the burners and keep

Flame Adjustment Knob
IH		P
	F	IL
			O
	F		T
	O
			O
			N	ON
LO				OFF

REMOTE

Control Knob in

the pilot lit by doing one of the following:

• Turn control knob clockwise

On Position

Remote Selector Switch in Remote Position (Optional Remote Control)

to the PILOT position.

• Use remote control manual OFF button.

Figure 33 - Setting the Remote Selector Switch, Control Knob, and Flame Adjustment Knob for Remote Operation

• Set remote selector switch in the OFF

position.

MANUAL LIGHTING

PROCEDURE

1.	Follow steps 1 through 6 under Light-
	ing Instructions, page 14.
2.	Depress control knob and light pilot
	with match.
3.	Keep control knob pressed in for 30
	seconds after lighting pilot. After 30

Shows Temperature Setting

The Log Heater will Automatically Cycle between Pilot and the Heat Setting that has been Selected

Increases Room

Temperature in

AUTO Mode

Decreases Room

Temperature in

AUTO Mode

Turns Burners On or Off and Allows You to Choose the Auto Setting

seconds, release control knob. Now

follow steps 9 through 11, page 14.

Figure 34 - Thermostat Hand-Held Remote Control Unit Selections (GHRCTA Series only)

Continued

105647 15 For more information, visit www.desatech.com