Desa VI33NR Owner’S Manual, Local Codes, Product Identification, Unpacking, Continued

Models: VI33NR

1 28
Download 28 pages 54.34 Kb
Page 3
Image 3
OWNER’S MANUAL

OWNER’S MANUAL

SAFETY

INFORMATION

Continued

12.Do not use fireplace insert if any part has been exposed to or under water. Immedi- ately call a qualified service technician to inspect the fireplace insert and to replace any part of the control system and any gas control which has been under water.

13.Do not operate fireplace insert if any log is broken. Do not operate fireplace insert if a log is chipped (dime-sized or larger).

14.Turn fireplace insert off and let cool before servicing. Only a qualified ser- vice person should service and repair fireplace insert.

15.Operating fireplace insert above eleva- tions of 4,500 feet could cause pilot outage.

LOCAL CODES

Install and use fireplace insert with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANSI Z223.1/NFPA 54*.

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

PRODUCT IDENTIFICATION

Optional

Remote

Control

Control

Knobs

Piezo

Remote Selector

Ignitor

Switch (Optional)

Figure 1 - Log Base Assembly

Top Louver

Assembly

Firebox

Hood

Firebox

Support

Screen

Assembly

Figure 2 - Fireplace Insert

One Piece

Continued Log Set

Top Outer

Casing

Gas Line

LOCAL CODES Access

Blower

Assembly

Bottom Louver Assembly

Quincy, MA 02269

UNPACKING

PRODUCT IDENTIFICATION CAUTION: Do not remove the warning and instruction labels attached to the heater base as- sembly. These markings contain important warranty information.

1.With utility knife, cut the carton all the way around above the staples on the bottom tray. Lift the carton off the heater. Remove packing. Note: The hood is located in the packing on the right hand side of the heater front. Lift the heater off the bottom tray.

2.Locate two screws above top corners of the fireplace insert screen. Remove and discard these screws. Lift fireplace insert screen up and pull out to remove.

3.Remove protective packaging applied to logs, log base assembly, and fire- place insert.

4.Remove fireplace insert hood from car- ton insert.

5.Check all items for any shipping dam- age. If damaged, promptly inform dealer where you bought fireplace insert.

REMOTE CONTROL ACCESSORIES

There are four optional remote controls that can be purchased separately for this fire- place insert:

wall switch

wall thermostat

hand-held ON/OFF remote

hand-held thermostat remote

See Accessories, page 26.

105647

3

For more information, visit www.desatech.com

Page 3
Image 3
Desa VI33NR Owner’S Manual, Local Codes, Product Identification, Unpacking, Remote Control Accessories, Continued