OWNER’S MANUAL
INSTALLATION
Continued
OPTIONAL WIRELESS HAND- HELD REMOTE CONTROL ACCESSORIES
(GHRC and GHRCTA)
Installing Remote Receiver Unit
1.Disconnect switch wires from the con- trol valve.
2.Remove screws attaching switchplate.
3.Remove switch plate (see Figure 25). Discard after removing.
4.Install remote receiver unit onto gas log heater base using mounting clips.
5.Push clips firmly into place (see Fig- ure 26).
6.Connect wires as shown in Figure 27.
Remote Switch | Ignitor |
Bracket |
|
Screw
White Wire
From Receiver
Valve
Red Wire From
Receiver
Figure 27 - Connecting Wires
INSTALLING
BATTERIES
Two
Installing 9-Volt Battery (Not Included) in Receiver
1. | Locate back of receiver under front |
| burner of heater. |
2. | Locate the battery clip mounted on the |
| back of the receiver. |
3. | Slide a |
Installing 9-Volt Battery (Not
Included) in Hand-Held Remote
Control Unit
1.Remove battery cover on back of re- mote control unit.
2.Attach terminal wires to the battery. Place battery into the battery housing.
3.Replace battery cover onto remote con- trol unit.
| Battery | Remote | |
Terminal | Control Unit | ||
Cover | |||
Wires |
| ||
|
| ||
|
| ||
Battery |
|
|
Battery
Housing
Figure 29 - Installing Battery in Hand- Held Remote Control Unit (GHRC Series)
Battery Wires
Switch Plate | Wires |
4. Attach the terminal wires to the battery. |
Remote
Receiver
Battery Cover
Remote
Control
Unit
Figure 25 - Switch Plate and Wiring Harness
Mounting
Clips
Remote Receiver
Figure 26 - Installing Remote Receiver
Terminal Wires
Battery Clip
Figure 28 - Installing Battery in Remote Receiver
Figure 30 - Installing Battery in
105647 | 13 | For more information, visit www.desatech.com |
