Bunn ITB Programming The Brewer, Programming Functions - Level, cont, Set Language, Brew Lockout

PROGRAMMING THE BREWER

PROGRAMMING FUNCTIONS - LEVEL 1

* BREW LOCKOUT

This function allows the operator to prevent or allow brewing if the water temperature is less than the set READY temperature.

Procedure for setting Brew Lockout:

1. To access this function screen press and hold the right hidden button. Release when the display reads:

BREW LOCKOUT?

NO DONE YES

Press here Press here Press here for NO for DONE for YES

2.The YES or NO should be flashing. Select YES to prevent brewing if the water temperature is below the set READY temperature. Select NO to permit brewing at any water temperature.

3.When finished, select DONE. This will exit this function screen and return to the MAIN SCREEN.

PROGRAMMING FUNCTIONS - LEVEL 2

The functions in the second level of programming allow the operator to adjust brew settings and other feature options.

To access the level 2 function screens press and hold the right hidden button for approximately 5 seconds. Release when the display reads:

* SET LANGUAGE

This function allows the operator to select the language used for the display.

Procedure for setting Language:

1.Press and hold the right hidden button until the display reads SET LANGUAGE? and release.

2.Press YES to proceed. The display should now read ENGLISH. Using (-)and (+), scroll through the available languages until the desired language is shown on the display.

3.When finished, press SELECT. If the language selected is different from the current settings,the display will read CHANGE LANGUAGE? ARE YOU SURE? and then will change to CHANGE LANGUAGE? To convert the display to the new language, select YES. To retain the current language, select NO.

4.The display should now read UNITS. To exit programming and return to the MAIN SCREEN, press ENABLE BREW ON/OFF switch.

(cont.)

Page 11 41581.2 091609