Bunn TWIN SET NEW Recipe Coffee only, SET NEW Coffee Items, Icb, Procedure for Setting the Recipe

NOT AVAILABLE ON ITB

PROGRAMMING THE BREWER (cont.)

PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)

* SET NEW RECIPE (COFFEE ONLY)

To set a new COFFEE recipe using a Smart Funnel and a G9-2T DBC or MHG Grinder:

This function allows the operator to set BREW VOL-

UMES, BYPASS %, PULSE BREW/PREINFUSION TIMES AND DRIP OUT TIMES for each coffee name stored in the grinder’s memory.

Certain coffee names are stored in the grinder’s memory. When a particular name of coffee is ground into the Smart Funnel, that name and the batch size selected are transferred from the grinder to the programming CHIP located in the funnel handle. The funnel is then inserted into the brewer’s funnel rails. The SENSING COIL on the brewer reads the information contained in the handle. The name of the coffee flavor will then ap- pear on the display. This allows the operator to set the

BREW VOLUMES, BYPASS % (N/A on ITCB), PULSE BREW/PREINFUSION TIMES AND DRIP OUT TIMES for that particular coffee name. Each coffee name can be set individually to provide optimum brewing quality.

SET NEW COFFEE ITEMS

ICB ITCB

Brew Ounces

% BypassDilution Ounces

Dilution Delay Time

Pulse Brew/Preinfusion Times

Drip Times

* SWEET METER

* ITCB WITH FACTORY SWEETENER

Procedure for Setting the Recipe:

NOTE: Before beginning setup, place a server beneath the brew funnel.

1.Insert the funnel into the grinder and select the small batch size to grind. It is not necessary to have coffee beans in the hopper(s) in order to program the brewer. The coffee name is pre-selected and stored in the grinder’s memory for the side being ground.

2.Press the GRIND switch. When the grinder stops grinding, remove the funnel.

3.On the brewer, press and hold the right hidden

switch until the display reads SET LANGUAGE. Press and release the right hidden switch until the display reads SET NEW RECIPE.

4.Select YES. The display should read INSERT FUN- NEL WITH NEW NAME, then QUIT SETUP? These two displays will repeatedly cycle.

5.Insert the funnel into the rails on the brewer (Left on Twins). The display should read the name of the coffee that was ground into the funnel, along with a NO and YES. If the name on the display is correct, press YES.

6.If, for some reason, the name of the coffee from the grinder did not load properly into the funnel, or if a grind has not yet been done, the display will read MUST GRIND INTO FUNNEL FIRST. It will be necessary to grind another batch following steps 1, 2 & 5.

NOTE: If brewer memory is full, the display will read RECIPE STORAGE AREA IS FULL and then REMOVE A FLAVOR? To remove a recipe press and release YES. Press NEXT to scroll through the stored recipes. When the display reads the name of the recipe to be removed, press and release REMOVE. The display will read REMOVE? Press CANCEL to exit the SET NEW RECIPE function. Press OK to remove that recipe. The display will then show BEGIN SETUP OF (COFFEE NAME).

7.If the grind is acknowledged by the brewer, the display will read BEGIN SETUP OF (COFFEE NAME). Then the screen will display BREW OZ and a batch light will be blinking. Follow steps on page 11 (Review Recipes) to adjust recipe settings.

Page 18 41581.2 091609