Using an AD CARD to load ADS:
The information is loaded into the brewer’s memory by holding the chip area up to the brewer’s SENSING COIL.
NOTE: Instructions to program the brewer are printed on the AD CARD.
Procedure to program the AD:
1.Remove the funnel(s) if present.
2.Position the RECIPE CARD vertically, so that the top end of the CHIP is beneath the (Left on Twins) SENSING COIL (located on the underneath side of the front display panel).
3.After a short pause the display will read CARD CONTAIN
4.To show (view) this information, select "SHOW". The display will scroll through all of the ad on that chip. The display will then return to CARD CONTAIN
5.If message is correct, press SAVE. The display will read AD MESSSAGE SETUP COMPLETE. The ad is now stored in the brewer’s memory.
6.If the ad is not correct, or it is desired to exit the setup before the ad is loaded into the brewer’s memory, press QUIT. The display will then return to the MAIN SCREEN.
READY TO BREW
WATER TEMP XXX°
POSITION CARD UNDER
SENSOR COIL
CARD CONTAIN ADS
SHOW QUIT SAVE
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
SCROLLS THROUGH |
|
| AD MESSAGE | ||
COMPLETE MESSAGE |
|
| |||
|
|
|
| SETUP COMPLETE | |
|
|
|
|
|
|
READY TO BREW
WATER TEMP 200°
NOTE: ENABLE ADS must be turned on in LEVEL 2 in order for the newly programmed ad message to be displayed.
Page 10 | 41581.2 091609 |
|
