Desa VI33PR Optional Wireless HAND- Held Remote Control Accessories, Installing 9-VOLT Batteries

OWNER’S MANUAL

INSTALLATION

Continued

2.Install fireplace insert screen by slip- ping notches of fireplace insert screen over screws on front of fireplace insert (see Figure 25).

WARNING: You must operate this fireplace insert with the fire- place insert screen in place. Make sure fireplace insert screen is in place before running fireplace insert.

Notches

Screws for

Mounting Screen

Figure 25 - Installing Fireplace Insert Screen

OPTIONAL WIRELESS HAND- HELD REMOTE CONTROL ACCESSORIES

(GHRC and GHRCT)

Installing Remote Receiver Unit

1.	Disconnect switch wires from the con-
	trol valve.
2.	Remove screws attaching switchplate.
3.	Remove switch plate (see Figure 26).
	Discard after removing.
4.	Install remote receiver unit onto gas log
	heater base using mounting clips.

Remote Switch	Ignitor
Bracket

Screw

Switch Plate Wires

Figure 26 - Switch Plate and Wiring Harness

Mounting

Clips

Remote Receiver

Figure 27 - Installing Remote Receiver

White Wire

From Receiver

Valve

Red Wire From

Receiver

Figure 28 - Connecting Wires

INSTALLING 9-VOLT

BATTERIES

Two 9-volt batteries (not included) are re- quired to operate this heater with the wire- less hand-held remote control set. Install one battery in the receiver and one in the hand-held remote control unit. Note: Only

2.Locate the battery clip mounted on the back of the receiver.

3.Slide a 9-volt battery through the clip.

4.Attach the terminal wires to the battery.

Remote

Receiver

Terminal Wires

Battery Clip

9-Volt Battery

Figure 29 - Installing Battery in Remote Receiver

Installing 9-Volt Battery (Not

Included) in Hand-Held Remote

Control Unit

1.Remove battery cover on back of re- mote control unit.

2.Attach terminal wires to the battery. Place battery into the battery housing.

3.Replace battery cover onto remote con- trol unit.

	Battery	Remote
Terminal		Control Unit
	Cover
Wires
9-Volt
Battery

Battery

Housing

Figure 30 - Installing Battery in Hand- Held Remote Control Unit (GHRC Series)

9-Volt Terminal

Battery Wires

5.	Push clips firmly into place (see Fig-
	ure 27).
6.	Connect wires as shown in Figure 28.

use alkaline batteries.

Installing 9-Volt Battery (Not Included) in Receiver

Battery Cover

Remote

Control

Unit

1.Locate back of receiver under front burner of heater.

Figure 31 - Installing Battery in Hand-Held Remote Control Unit (GHRCTA Series)

105648 13 For more information, visit www.desatech.com