OWNER’S MANUAL
SAFETY
INFORMATION
Continued
11.Do not run fireplace insert
•where flammable liquids or vapors are used or stored
•under dusty conditions
12.Do not use this fireplace insert to cook food or burn paper or other objects.
13.Do not use fireplace insert if any part has been exposed to or under water. Immedi- ately call a qualified service technician to inspect the fireplace insert and to replace
any part of the control system and any gas control which has been under water.
14.Do not operate fireplace insert if any log is broken. Do not operate fireplace insert if a log is chipped
15.Turn fireplace insert off and let cool be- fore servicing. Only a qualified service person should service and repair fire- place insert.
16.Operating fireplace insert above eleva- tions of 4,500 feet could cause pilot outage.
17.To prevent performance problems, do not use propane/LP fuel tanks of less than 100 lbs. capacity.
LOCAL CODES
Install and use fireplace insert with care. Fol- low all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANS Z223.1, also known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
UNPACKING
PRODUCT IDENTIFICATION
Optional
Remote
Control
IH |
|
| O |
NO | FF |
Control
Knobs Piezo
Ignitor Remote Selector
Switch (Optional)
Figure 1 - Log Base Assembly
Firebox
Hood
Firebox
Support
Screen
Assembly
Figure 2 - Fireplace Insert
One Piece Log Set
Top Outer
Casing
Top Louver
Assembly
Gas Line
Access
Bottom Louver | Blower Assembly | |
Assembly | ||
|
CAUTION: Do not remove the warning and instruction labels attached to the heater base as- sembly. These markings contain important warranty information.
1.With utility knife, cut the carton all the way around above the staples on the bottom tray. Lift the carton off the heater. Remove packing. Note: The hood is located in the packing on the right hand side of the heater front. Lift the heater off the bottom tray.
2.Locate two screws above top corners of the fireplace insert screen. Remove and discard these screws. Lift fireplace insert screen up and pull out to remove.
3.Remove protective packaging applied to logs, log base assembly, and fireplace insert.
4.Remove fireplace insert hood from car- ton insert.
5.Check all items for any shipping dam- age. If damaged, promptly inform dealer where you bought fireplace insert.
REMOTE CONTROL ACCESSORIES
There are four optional remote controls that can be purchased separately for this log heater insert:
•wall switch
•wall thermostat
•
•
105648 | 3 | For more information, visit www.desatech.com |
