Desa (V)KC42PE Continued, Installing Lava Rock and Glowing Embers, page, Handset

Fireplace

Installation

Continued

7.Remove three screws from deflector shield on the inside top of firebox. Set shield and screws aside.

8.Install rear brick panel first. Rest bottom edge of panel on back edge of burner assembly (see Figure 39).

9.Install left side brick panel by sliding it be- tween the burner assembly and the side of the firebox (see Figure 39).

10.Install the right brick panel using the same method described in step 6 for left brick panel.

11.Replace deflector shield using screws removed in step 7.

12.Using screws removed in step 6, replace plenum and attach to burner.

13.Carefully replace the ember pod and log set.

14.Use screws removed in step 4 to replace andiron assembly.

15.Install lava rock and glowing embers. See

Installing Lava Rock and Glowing Embers, page 25.

16.Close glass door and lock latches on top and bottom of door and replace screen. See Re- moving Glass Door, steps 5 and 6, page 25.

17.Replace top and bottom louvers.

Left Side Brick

Panel

WALL SWITCH INSTALLATION

The installation of a wall switch allows you to ac- tivate the gas control valve and turn the fireplace on and off. The wall switch is to be connected to the incoming 120 volt regular household wiring that supplies the electricity to the fireplace.

optional Remote control INSTALLATION (model WRC)

Note: If using optional wireless hand-held remote control, the wall switch must be in the ON position to be operational. The remote control then becomes the switching mechanism for fireplace operation.

1.Open lower louver panel.

2.The WRC model receiver does not require a battery. The receiver can be installed by first plugging the short extension cord into the fireplace receptacle. Then plug the receiver unit into the extension cord. Finally plug the ignition module plug into the receiver unit (see Figure 40).

3.Activate the remote handset battery by removing the insulating tab on the back of the handset (see Figure 41). The battery is included pre-installed.

4.Once the battery is activated the unit is ready to use.

5.Close lower louver panel.

Remote

FireplaceControl

Receptacle Receiver

Extension Cord	Ignition
	Module Plug

Figure 40 - Installing the WRC Remote

Receiver

Battery Cover

12 Volt Battery

Rear Brick Panel

Figure 39 - Installing Rear Brick Panel

Back of	Pull to Remove
Handset
	Insulation Tab

Figure 41 - Installing Battery into Back of

Handset

26 www.desatech.com 116240-01E