Desa VP1600E, VP2600E Infrared Propane/Lp Gas Heater, Installation, Continued, Mounting Bracket

Models: VP1600E VP2600E

1 24
Download 24 pages 35.24 Kb
Page 8
Image 8
Mounting Bracket

®

INFRARED PROPANE/LP GAS HEATER

INSTALLATION

Continued

INSTALLING HEATER TO WALL

Mounting Bracket

Locate mounting bracket in heater car- ton. Remove mounting bracket from heater carton.

Removing Front Panel Of Heater Mounting

Bracket

Figure 5 - Mounting Bracket Location

Removing Front Panel Of Heater

1.Remove two screws near bottom cor- ners of front panel.

2.Lift straight up on grill guard until it stops. Grill guard will slide up about 1/4".

3.Pull bottom of front panel forward, then down.

Figure 6 - Removing Front Panel Of Heater

Methods For Attaching Mounting Bracket To Wall

Only use last hole on each end of mounting bracket to attach bracket to wall. These two holes are 16 inches apart from their centers. Attach mounting bracket to wall in one of two ways.

1.Attaching to wall stud

2.Attaching to wall anchor

Attaching To Wall Stud: This method pro- vides the strongest hold. Insert mounting screws through mounting bracket and into wall studs.

Attaching To Wall Anchor: This method allows you to attach mounting bracket to hollow walls (wall areas between studs) or to solid walls (concrete or masonry).

Decide which method better suits your needs. Either method will provide a secure hold for the mounting bracket.

Marking Screw Locations

1.Tape mounting bracket to wall where heater will be located. Make sure mounting bracket is level.

Methods For Attaching Mounting Bracket To Wall WARNING: Maintain mini- mum clearances shown in Figure

7.If you can, provide greater clear- ances from floor and joining wall.

2.Mark screw locations on wall (see Fig- ure 7).

Note: Only mark last hole on each end of mounting bracket. Insert mounting screws through these holes only.

13"

16"

Min.

 

AdjoiningWall

 

Only Insert Mounting

18 3/4"

 

 

Screws Through Last

 

 

Min.

 

 

Hole On Each End

 

 

 

 

 

 

 

Floor

 

 

 

 

Model VP2600E

 

 

 

9 1/4"

16"

 

 

 

Min.

 

 

 

AdjoiningWall

Only Insert Mounting

18 3/4"

Screws Through Last

 

Min.

 

 

Hole On Each End

 

 

 

 

 

Floor

Model VP1600E

Figure 7 - Mounting Bracket Clearances

3.Remove tape and mounting bracket from wall.

8

103351

Page 8
Image 8
Desa VP1600E Infrared Propane/Lp Gas Heater, Installation, Continued, Mounting Bracket, Removing Front Panel Of Heater