16
VENTING INSTALLATION INSTRUCTIONS
Parts Lists for Venting Kits and Components
FIREPLACE INSTALLATION
Check Gas Type
Installing Optional Blower Accessories
VENTING INSTALLATION INSTRUCTIONS
Continued
PARTS LISTS FOR VENTING KITS AND COMPONENTS
DESA International Pipe & Vent Kits
Number Description
Includes:45°
Includes: 45° Elbow,
Includes: 45° Elbow,
| Includes: 45° Elbow, |
| strictor, Vertical High Wind Termination, 2' Pipe, 4' Pipe, |
| Firestop Plate, Roof Flashing |
| Includes: 45° Elbow, |
| zontal Termination, 6" Pipe, 90° Elbow, Wall Firestop, |
| and 18 Screws |
HTK | Horizontal Round Termination Kit |
| Includes: Round Termination, Wall Firestop, and 45° Elbow |
DESA International Elbows
Number | Description |
45° Elbow - Galvanized | |
90° Elbow - Galvanized |
DESA International Terminations
Number Description
DESA International Venting Accessories
Number | Description |
Storm Collar - Galvanized | |
Wall Firestop - Galvanized | |
Roof Flashing - 0 to 6/12 Pitch - Galvanized | |
Roof Flashing - 6/12 to 12/12 Pitch - Galvanized | |
Vertical Restrictor - Galvanized | |
Combustible Siding Standoff - Galvanized | |
Wall Strap | |
Firestop Plate |
FIREPLACE INSTALLATION
CHECK GAS TYPE
Use proper gas type for the fireplace unit you are installing. If you have conflicting gas types, do not install fireplace. See retailer where you purchased the fireplace for proper fireplace according to your gas type.
INSTALLING OPTIONAL BLOWER
ACCESSORIES
NOTICE: If installing blower in an existing fireplace with gas connections, shut off gas supply and dis- connect heater from gas supply. Contact a qualified service person to do this.
WARNING: If there is a duplex electrical outlet installed in the right side of the bottom of the fireplace base area, be sure that the electrical power to the outlet is turned off before proceeding with blower installation. Failure to do this may result in serious injury.
Model BK Installation
Follow all instructions provided in the blower accessory kit.
1.Attach the power cord to the blower motor by firmly pushing the two female terminals at the end of the power cord onto the two spade terminals on the blower motor (see Figure 25, page 17).
2.Attach green ground wire from power cord to blower housing using screw provided (see Figure 25, page 17). Tighten screws securely.
For..com