Fireplace Installation
Continued
5.Place log #5 (top log) onto right pin of front log (#2) and the smooth surface of crossover log (#4) as shown in Figure 44. Make sure it is seated properly.
6.Place log #6 (left log) onto left pin of front log (#2) and the smooth surface of rear log (#3) as shown in Figure 45. Make sure it is seated properly.
7.For 42" series only, place log #7 onto right pin of top log (#5) as shown in Figure 45. Make sure it is seated properly
8.Place lava rock along sides and front of firebox bottom in areas that are visible only. It is not necessary to use all of the lava rock provided.
NOTICE: Do not put lava rock on burner or under burner. Placing lava rock on burner will cause performance problems.
9.Pull ember material apart into pieces no larger than a dime. Place these pieces loosely and sparingly directly onto the exposed sec- tion of the front burner and along the space between the burner and grate prongs (see Figure 46). This will create the glowing ember appearance as the flame touches the ember material. Do not block air slots by using too much ember material in one area. It is not necessary to use all of the ember material provided.
10.Close glass door, lock door latches, replace screen, and close louvers (see Removing/Replacing Glass Door, steps 5 through 7, page 19).
WARNING: The glass door must be securely in place before running this fireplace. Do not run this fireplace if glass is missing or broken.
5
Figure 44 - Installing Log No. 5
6 | 7 |
|
42" Series Only
Figure 45 - Installing Log No. 6 (36" and 42" Series) and
Log No. 7 (42" Series Only)
Ember Material
Figure 46 - Placing Ember Material on Burner
WALL SWITCH INSTALLATION
The installation of a wall switch allows you to activate the gas control valve and turn the fireplace on and off. The wall switch is to be connected to the incoming 120 volt regular household wir- ing that supplies the electricity to the fireplace. Refer to wiring diagram below.
optional Remote control
INSTALLATION (model WRC)
Note: If using optional wireless
1.Open lower louver panel of firebox.
2.The WRC model receiver does not require a battery. The receiver can be installed by first plugging the short extension cord into the fireplace receptacle. Then plug the receiver unit into the extension cord. Finally plug the ignition module plug into the receiver unit (see Figure 47).
3.Activate the remote handset battery by removing the insulating tab on the back of the handset (see Figure 48). The battery is included
4.Once the battery is activated the unit is ready to use.
5.Close lower louver panel.
Fireplace |
|
Receptacle | Remote Control |
| |
| Receiver |
Extension Cord | Ignition | |
Module Plug | ||
|
Figure 47 - Installing the WRC Remote Receiver
Battery Cover
12 Volt Battery
Back of | Pull to Remove |
Handset | Insulation Tab |
Figure 48 - Installing Battery into Back of Handset
www.desatech.com | 21 |
