UNVENTED PROPANE/LP GAS FIREPLACE
INSTALLATION
Continued
Mantel Clearances for Built-In Installation
If placing mantel above
6. | While firmly holding edges of brass trim |
| together, tighten both set screws on the |
| adjusting plate with slotted screwdriver. |
7. | Repeat steps 1 through 6 for other side. |
8. | Tighten trim hanging screws (#10 x |
| 6.25 shoulder) into holes in cabinets. |
| Place the assembled trim onto fireplace |
| cabinet. Align hanging notches on trim |
| with hanging screws on side of fire- |
| place (see Figure 38). Push trim firmly |
Wall board or facing material (above firebox) may be of combustible material, including decorative
Mantel Shelf
into place, sliding hanging notches over |
hanging screws. |
Side | Set Screws | Top |
mantel ornaments or
other similar projec- tions off of the facing material.
Framing
Material
8"
6"
21/2"
Brass | Brass |
Trim | Trim |
| Adjusting |
| Plate |
Firebox
Noncombustible Material May Project Off this Surface above the Firebox Hood
13" 16" 19" 21"
Note: All vertical
Slot
Shim
Slot
Mitered Edge
Supplied Firebox
Hood Must Be
Used at All Times
measurements are from top of fireplace hood opening to bottom of mantel shelf.
These minimum clearances replace any other recommended clearances supplied with your ANS Z21.11.2 approved gas logs.
Figure 37 - Assembling Brass Trim
Trim
Hanging
Screws
Figure 36 - Minimum Mantel Clearances for Built-In Installation
Hanging Notches
NOTICE: Surface temperatures of adjacent walls and mantels be- come hot during operation. Walls and mantels above the firebox may become hot to the touch. If installed properly, these tempera- tures meet the requirement of the national product standard. Fol- low all minimum clearances shown in this manual.
NOTICE: If your installation does not meet the minimum clearances shown, you must do one of the following:
•raise the mantel to an accept- able height
•remove the mantel
ASSEMBLING AND ATTACHING OPTIONAL BRASS TRIM (Included with Mantel Accessory)
INote: The instructions below show assem- bling and attaching brass trim to fireplace.
1.Remove packaging from three pieces of brass trim.
2.Locate four brass screws, two adjust- ing plates with set screws, and two shims in the hardware packet.
3.Align shim under adjusting plate as shown in Figure 37.
4.Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see Figure 37).
5.Slide other end of adjusting plate/shim in slot on mitered edge of side brass trim (see Figure 37).
on Trim
Assembled
Brass Trim
Figure 38 - Attaching Brass Trim to Fireplace
INSTALLING HOOD
Install hood to top of firebox as shown in Figure 39. Use 3 Phillips screws provided.
Figure 39 - Installing Hood to Firebox
For more information, visit www.desatech.com | 18 | 107570 |
