UNVENTED PROPANE/LP GAS FIREPLACE
INSTALLATION |
Continued |
Manual Gas |
Valve |
Figure 28 - Checking Gas Joints
Equipment Shutoff Valve
Propane/LP
Supply Tank
5.Route flexible gas line through access hole in hearth base.
6.Center cabinet mantel on hearth base (see Figure 30). Make sure mantel is flush against wall.
7.Break off nailing flanges (see Figure 31) with hammer or pliers.
8.Place cardboard or other protective ma- terial on top of hearth base. Carefully set fireplace on protective material, with back of fireplace inside mantel opening.
9.Attach flexible gas line to fireplace gas regulator. See Connecting Fireplace to Gas Supply, page 15.
Cabinet
Mantel
CONVENTIONAL FIREPLACE INSTALLATION
Conventional installation of fireplace involves installing fireplace along with corner, face, or cabinet mantel with hearth base accessories against a wall in your home. Follow instruc- tions below to install fireplace in this manner.
Note: The instructions below show installa- tion using the cabinet mantel and hearth base accessories (see Accessories, page 34). The hearth base accessory shown is optional for this installation. You can install fire- place and cabinet mantel directly on the floor. The corner mantel accessory cannot be installed with the hearth bases. You must install corner mantel directly on the floor.
1.Assemble cabinet mantel, hearth base, and trim accessories. Assembly instruc- tions are included with each accessory.
2.When installing blower, install a prop- erly grounded, 120 volt
3.If not already completed, install gas piping to fireplace location. This instal- lation includes an approved flexible gas line (if allowed by local codes) after the equipment shutoff valve. The flex- ible gas line must be the last item in- stalled on the gas piping. See Install- ing Gas Piping to Fireplace Location, page 14.
4.Place hearth base accessory against wall at installation location. Cut an ac- cess hole in hearth top to run flexible gas line to fireplace (see Figure 29). Make sure to locate access hole so cabi- net mantel will cover it when installed. Note: You can secure base to floor us- ing wood screws. Countersink screw heads and putty over.
| Flexible | Electrical | Gas Line | |
Hearth | Outlet | Access | ||
Gas Line | ||||
Base |
| Hole | ||
|
|
Figure 29 - Placing Hearth Base Accessory Against Wall
Figure 30 - Installing Cabinet Mantel
Nailing
Flanges
Figure 31 - Location of Nailing Flanges
For more information, visit www.desatech.com | 16 | 107570 |
