INSTALLING
Continued
10
ASSEMBLING AND ATTACHING BRASS TRIM
Note: The instructions below show assembling and attaching brass trim to fireplace. Do not yet install trim if performing a
1.Remove packaging from three pieces of brass trim.
2.Locate four brass screws, two adjusting plates with set screws, and two shims in the hardware packet.
3.Align shim under adjusting plate as shown in Figure 5.
4.Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see Figure 5).
5.Slide other end of adjusting plate/shim in slot on mitered edge of side brass trim (see Figure 5).
6.While firmly holding edges of brass trim together, tighten both set screws on the adjusting plate with slotted screwdriver.
7.Repeat steps 1 through 6 for other side.
| Set Screws | Top Brass Trim |
Side Brass Trim | Adjusting | |
|
| |
| Plate |
|
Shim
Slot
Mitered Edge
Slot
Figure 5 - Assembling Brass Trim
8.Tighten trim hanging screws (#10 x 6.25 shoulder) into holes in cabinets. Place the assembled trim onto fireplace cabinet. Align hanging notches on trim with hanging screws on side of fireplace (see Figure 6). Push trim firmly into place, sliding hanging notches over hanging screws.
Trim Hanging
Screws
Assembled
Brass Trim
Hanging
Notches on
Trim
Figure 6 - Attaching Brass Trim to Fireplace
102664