OPERATING FIREPLACE
Thermostat- Controlled Model
Continued
22
LIGHTING INSTRUCTIONS
WARNING
WARNING ICON | G 001 |
You must operate this fireplace with the fireplace screen in place. Make sure fireplace screen is installed before running fireplace.
NOTICE
During initial operation of new fireplace, burning logs will give off a
1.STOP! Read the safety information on page 21.
2.Make sure manual shutoff valve is fully open.
3. Turn control knob clockwise Clockwise
to the OFF position.
Control Knob
Ignitor Button
Figure 25 - Control Knob and Ignitor Button Location
4.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information above. If you don’t smell gas, go to the next step.
5. Turn control knob counterclockwise 
to the PILOT position. Press in control knob for five (5) seconds (see Figure 25, above).
Note: If running fireplace for first time, there will be air in gas line. You may need to press in control knob for 30 seconds or longer. This will allow air to bleed from the gas system.
6.Continue pressing control knob in. Press and release ignitor button. This will light pilot. The pilot is attached to the front burner. If needed, keep pressing ignitor button until pilot lights.
7.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.
•If control knob does not pop out when released, contact a qualified service person or gas supplier for repairs.
Note: If pilot goes out, repeat steps 3 through 7. This fireplace has a safety interlock system. Wait one (1) minute for system to reset before lighting pilot again.
Note: If pilot does not stay lit, contact a qualified service person or gas supplier for repairs. Until repairs are made, light pilot with match. To light pilot with match, see Manual Lighting Procedure, page 23.
Thermocouple | Ignitor Electrode |
Pilot Burner
Figure 26 - Pilot102664
