Desa Tech CGF280NT Cleaning, Maintenance, Trouble, Shooting, can damage ODS/pilot unit, Observed

CLEANING	WARNING ICONG 001		WARNING
AND	Turn off fireplace and let cool before cleaning.
MAINTENANCE
	WARNING ICONG	001	CAUTION

You must keep control areas, burners, and circulating air pas- sageways of fireplace clean. Inspect these areas of fireplace before each use. Have fireplace inspected yearly by a qualified service person. Fireplace may need more frequent cleaning due to excessive lint from carpeting, bedding material, etc.

ODS/PILOT AND BURNERS

• Use a vacuum cleaner or small, soft bristled brush to clean.

LOGS

•If you remove logs for cleaning, refer to Installing Logs, pages 20 and 21, to properly replace logs.

•Replace log(s) if broken or chipped (dime-sized or larger).

TROUBLE-			WARNING ICONG 001 WARNING
SHOOTING	Turn off fireplace and let cool before servicing. Only a qualified
	service person should service and repair fireplace.
Note: All troubleshooting
items are listed in order of
			WARNING ICONG 001 CAUTION
operation.
	Never use a wire, needle, or similar object to clean ODS/pilot. This
	can damage ODS/pilot unit.
	OBSERVED	POSSIBLE
	PROBLEM	CAUSE		REMEDY
	When ignitor button	1.	Ignitor cable pinched or	1.	Free ignitor cable if
	is pressed, there is no		wet		pinched by any metal or
	spark at ODS/pilot				tubing. Keep ignitor
					cable dry
		2.	Ignitor electrode not con-	2.	Reconnect ignitor cable
			nected to ignitor cable
		3.	Piezo ignitor nut is loose	3.	Tighten nut holding
					piezo ignitor to base
					panel of log set. Nut is
					located behind base
					panel.
		4.	Broken ignitor cable	4.	Replace ignitor cable
		5.	Ignitor electrode broken	5.	Replace ignitor
		6.	Bad piezo ignitor	6.	Replace piezo ignitor
		7.	Ignitor electrode posi-	7.	Replace ignitor
			tioned wrong
					Continued
					27

102664