UNVENTED
INSTALLATION
Continued
INSTALLING LOGS
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Slide rear log (#1) into place behind rear burner. Make sure flat areas at bot- tom of log are behind front burner (see Figure 17).
2 . Slide bottom mid log (#2) into place in behind front burner. Make sure tabs at bottom of log are behind rear burner (see Figure 18).
3.Place front log (#3) into place in front of bottom mid log (#2) (see Figure 19). Make sure notches on bottom rest on grate prongs.
4.Finally place top log (#4) over bottom mid log (#2) by matching the notches under log (#4) with the raised blocks of log (#2) (see Figure 20).
Rear Log (#1)
Figure 17 - Installing Rear Log
Bottom Mid Log (#2)
2
Tab
Figure 18 - Installing Bottom Mid Log
Front Log (#3)
3
Figure 19 - Installing Front Log
Top Log (#4)
4
4
Figure 20 - Installing Top Log
14 | 103425 |
