OWNER’S MANUAL
INSTALLATION
Installation Items Needed
•hardware package (provided with heater)
•approved flexible gas hose (not provided) (if allowed by local codes)
•sealant (resistant to propane/LP gas, not provided)
•electric drill with 3/16" masonry drill bit
1.Apply pipe joint sealant lightly to male threads of gas connector and install into regulator. Connect approved flexible gas hose to gas regulator of heater (see Figure 11).
IMPORTANT: Hold gas regulator with wrench when connecting fittings.
2.Position heater base assembly in fire- place.
3.Mark screw locations through holes in front of base. If installing in a brick- bottom fireplace, mark screw locations in mortar joint of bricks.
4.Remove heater base from fireplace.
5.Drill holes at marked locations using 3/16" drill bit. Drill at a 45° angle.
6.Attach base to fireplace floor using masonry screws in hardware package (see Figure 12).
7.Connect to gas supply. See Connecting To Gas Supply, page 12.
Heater Gas
Regulator
Flexible Gas Hose (if allowed by local codes)
Figure 11 - Attaching Flexible Gas Hose to Heater Gas Regulator
Masonry
Screw
Figure 12 - Attaching Heater to Fireplace Floor
Continued
103425 | 11 |
