Desa Tech ELCG 240, ELCG 347 manual Operating Instruction, Main Power Button, Heater Control Button

OPERATING INSTRUCTION

The infrared remote control relies on a line of sight and must be pointed at the controls of the log set

to work. The remote control unit has the controls required to turn ON/OFF both the main power and

the heater. If you prefer to use the control buttons on the log set unit itself, they are on the lower right corner of the unit. The layout of the buttons and remote control unit can be seen in Figures 3 and 5,

respectively.

1.	Plug your log set into a 15-amp, 120-volt power outlet.	Figure 4
2.	Turn the power on. Flame will show on the wall behind
		The plastic tab inside the battery
	the log set.
3.	Remove plastic tab from inside battery compartment	compartment MUST be removed
		before remote control will operate.
	to activate remote control.
			(Pull tab)
4.	Point the remote control directly at the control buttons of
	the log set and use the buttons to operate the
	log set.

1 Main Power Button:

This button supplies power to all the functions of the log set. The main power button must be in the ON position, either from the remote or the controls on the log set for the functions to work.

2	Heater Control Button:
	This button controls the heater ON/OFF and 5
	temperature modes from Low to High. When
	the heater is first turned on, the heater will come on at
	the lowest room temperature setting. The log set will	Figure 5
	remember the last heat setting and in later use the heater
	will start at that setting, unless power to the unit has been
	interrupted. Each time the Temperature button is pressed,		1
	the temperature set point increases, allowing you to adjust
	the ambient temperature.

3	Flame Control button:	2
	This button controls the brightness of the flame effect with
	settings at High, Medium and Low. When the log set is first
	turned on, the flame will come on at the highest setting. The
	log set will remember the last flame setting used and in later	3
	use the flame brightness will start at that setting, unless

power to the unit has been interrupted. Each time the Flame

button is pressed, the flame brightness decreases. The only way to turn off the flame effect completely is to turn off the

Main Power button.

10