Desa Tech SL30NT installation manual Vent-Freenatural Gas Stove Heater, Installation, Continued

VENT-FREE NATURAL GAS STOVE HEATER

INSTALLATION

Continued

INSTALLING GAS LOG HEATER INTO STOVE

1.	Remove log and gas log heater from
	carton. Note: Do not pick up gas log
	heater by the burner itself. This could
	damage heater. Always handle the gas
	log heater by the heater base only.
2.	Remove all protective packaging applied
	to log and gas log heater for shipment.
3.	Check all items for any shipping dam-

7. Fasten heater base to stove bottom with

#10-24 x .50 bolts and hex nuts pro-

vided with gas log heater (see Figure

14). Attachment hardware is factory

packed inside plastic bag with installa-

tion manual and owner’s registration

card. Push bolt through heater base

mounting hole and through stove bot-

tom. Connect hex nut to bolt on under-

side of stove bottom. The bolt hex head

is for a 5/16" socket and the hex nuts

are for a 3/8" socket. If sockets are not

available, use adjustable wrenches.

8. Set one-piece log on heater base as

	Heater
Bolt	Base

	Stove
Hex Nut
	Bottom

Figure 14 - Fastening Heater Base to Stove Drop Bottom

	age. If damaged, promptly inform
	dealer where you bought heater.
4.	If not already removed, remove back
	panel from assembled stove body (see
	Figure 5, page 8). Use an adjustable
	wrench or a 10 mm socket. Remove six
	(6) bolts and washers. Keep bolts and
	washers to reattach back panel later.
5.	Set gas log heater inside stove (see Fig-
	ure 13). Make sure control knob exten-
	sions pass through bottom front opening.
6.	Align outside holes on heater base with
	four (4) mounting holes on the stove
	bottom (see Figure 13).

	shown in Figure 15. Make sure middle
	section at bottom of log is seated into
	"U" shaped cutout in center of heater
	base. Log will fit securely on base.
	IMPORTANT: Make sure log does not
	cover any burner ports and does not
	touch the stove cavity (see Figure 16).
9.	Fasten back panel to stove with six (6)
	M6 x 1.20mm bolts and washers. Make
	sure product identification label is lo-
	cated on the outside lower left-hand
	corner.
10.	Place freestanding stove in desired po-
	sition in room. Be sure to maintain
	clearances to combustibles as outlined
	on page 7.

Heater Base

LO

FFO

One-Piece

Log Set

Middle

Section at

Bottom of

Log Set

Burner

"U" Shaped

Cutout in

Chassis

Figure 15 - Installing One-Piece Stove Log Set

Burner

Bottom

Front

Opening

Bolt

Stove

Heater Bottom

Base

Figure 13 - Placing Heater Base In Stove Cavity (Appearance May Vary Depending on Model)

Burner Porting Areas (double slotted rectangular openings

Safety Pilot Location	One-Piece
	Log Set

Figure 16 - Top View of One-Piece Log Set on Gas Log Heater

10 104463