OWNER’S MANUAL
INSTALLATION
Continued
9. | Fasten stove bottom to stove with four |
| (4) M6 x 1 - 25mm bolts. Use a flat |
| washer and lock washer with each bolt. |
| Tighten bolts into threaded holes on |
| stove body (see Figure 8, page 8 and |
| 10). Use an adjustable wrench or a |
| 10mm socket. |
10. Attach stove door by inserting step bolt | |
| through door hinge pivot holes and into |
| threaded hole in stove body (see Fig- |
| ure 11). Use an adjustable wrench or a |
| 12mm socket to fasten step bolt. |
| Tighten step bolt until snug. Make sure |
| door moves freely. |
11. | Install door catch bolt (M8 x 1.25- |
| 55mm with two M8 hex nuts) into |
Washers 
Bolt | Bolt | Bottom Of |
| ||
| Stove Unit | |
Bottom Of |
| |
| Stove | |
Stove Unit |
| |
| Bottom | |
Leg |
| |
Figure 9 - Attaching Stove Legs | Figure 10 - Attaching Stove Bottom | |
threaded hole on stove body (see Fig- |
ure 8, page 8). Use an adjustable |
wrench or a 12mm socket. The catch |
bolt has two hex nuts attached to it (see |
Figure 12). The top nut is a bolt stop |
and the bottom nut is for door leveling |
adjustment. |
12. Check general catch bolt alignment |
with door claw. Make final adjustment |
and door leveling after stove is in nor- |
mal standing position. |
13. Carefully lift stove back up on its four |
attached legs. |
14. If available, install gas log heater in- |
side stove cavity before installing the |
back panel (see Installing Gas Log |
Heater Into Stove, page 10). |
Stove
Door
Door
Hinge
Step
Bolt
Bolt
Shoulder
Stove
Door
Threaded | Bolt |
Hole | Shoulder |
Door
Hinge
Step
Bolt
Stove Bottom
15. Fasten back panel to stove with six (6) |
M6 x 1 - 20mm bolts and washers. |
Make sure product identification label |
is located on the outside in lower left- |
hand corner. |
Figure 11 - Attaching Stove Door (Appearance May Vary Depending on Model)
Bolt Stop
Adjusting Nut
Door | Door Claw |
Catch Bolt
Figure 12 - Catch Bolt and Door Claw Orientation
Continued
104463 | 9 |
