OPERATION
SHUTTING DOWN YOUR PRESSURE WASHER
1.If you have siphoned chemicals or cleaners, you must siphon clean water through chemical hose to flush chemical injector.
2.Continue to siphon clean water through hose and pump for at least one minute before turning off engine.
NOTE
Failure to siphon clean water through chemical hose and pump after siphoning chemicals or cleaners can cause damage to pump.
3.Move throttle control to STOP position to stop engine.
Throttle Control
Fast
Slow
4.Turn engine switch to OFF position.
Engine Switch
OFF
ON
5. Move fuel valve lever to OFF position.
Fuel
Valve
Lever
ON
OFF
6. Turn off water supply.
Never turn water supply off while pressure washer engine is running or damage to pump will result.
DO NOT let hoses come in contact with very hot engine muffler during or immedi- ately after use of your pressure washer. Damage to hoses from contact with hot engine surfaces will NOT be covered by warranty.
7.Pull trigger on spray gun to relieve any water pressure in hose or spray gun.
8.Disconnect water supply hose from pump.
9.Coil high pressure hose and store in gun/hose holder.
10.Place spray gun in gun/hose holder.
11.Place chemical hose in gun/hose holder.
D20249 | 14 — ENG |
