ASSEMBLY
1.Connect threaded end of quick connect wand to spray gun as shown. Tighten securely.
2.Place assembled spray gun, quick connect, wand, and chemical hose in gun/hose holder.
3.Add 30 weight engine oil (supplied) to engine. Refer to engine manual supplied by engine manu- facturer for procedure. Do not overfill. Use of a funnel is recommended.
NOTE
There will be a slight amount of oil in the engine from factory testing.
NOTE
The engine on this pressure washer is equipped with a low oil sensor. The amount of oil in the engine must be correct or the engine will not start.
THE PUMP IS SHIPPED FROM THE FAC- TORY WITH OIL IN IT AND A RED SHIP- PING PLUG TO PREVENT ANY OIL FROM LEAKING OUT OF THE PUMP DURING SHIPMENT. ATTACHED TO THE SHIPPING PLUG IS A PLASTIC BAG (SEE THE FOL- LOWING PHOTO) WHICH CONTAINS THE DIPSTICK/OIL PLUG THE SHIPPING PLUG MUST BE REMOVED AND THE DIPSTICK/ OIL PLUG INSTALLED BEFORE THE PRES- SURE WASHER IS OPERATED.
4.Using a 17 mm wrench, remove shipping plug from pump by turning it counterclockwise. Dis- card plug.
5.Remove dipstick/oil plug from plastic bag. Before installing dipstick/oil plug into pump, check the pump oil level. See Pump paragraph in Mainte- nance section of this manual.
6.Remove five colored quick connect nozzles from plastic bag and insert them into correct receptacle on panel NOTE: Nozzles are color coded to match colored squares on panel.
7 — ENG | D20249 |
