OPERATION
3.Move throttle control lever out of SLOW position, about 1/3 of the way toward FAST position.
Throttle Control
Slow
Fast |
4. Turn engine switch to ON position.
Engine Switch
OFF
ON
5.Pull starter grip slowly until you feel resistance, then pull briskly. Return starter grip gently.
Starter Grip
If engine does not start after two pulls, pull the trigger on spray gun to relieve pressure in hose. Failure to do so may cause dam- age to starter recoil mechanism of engine
NEVER RUN ENGINE INDOORS OR IN EN- CLOSED, POORLY VENTILATED AREAS. ENGINE EXHAUST CONTAINS CARBON MONOXIDE, AN ODORLESS AND DEADLY GAS.
6.If choke control lever is in CLOSED position, move lever to OPEN position as engine warms up.
7.Move throttle control to FAST position.
Throttle Control
Slow
Fast |
WHEN USING THE HIGH PRESSURE SETTING, DO NOT ALLOW THE HIGH PRESSURE SPRAY TO COME IN CONTACT WITH UNPROTECTED SKIN, EYES, OR WITH ANY PETS OR ANIMALS. SERIOUS INJURY CAN OCCUR.
DO NOT stop spraying water for more than two minutes at a time. Pump operates in bypass mode when spray gun trigger is not pressed. If pump is left in bypass mode for more than two minutes internal components of the pump can be damaged.
DO NOT let hoses come in contact with very hot engine muffler during or immedi- ately after use of your pressure washer. Damage to hoses from contact with hot engine surfaces will NOT be covered by warranty.
7.Depress trigger on gun to start water flow. Release trigger to stop water flow.
STAND ON A STABLE SURFACE AND GRIP GUN/WAND FIRMLY WITH BOTH HANDS. EXPECT THE GUN TO KICK WHEN TRIGGERED.
9.Adjust nozzle spray for the task being performed. See Spray Nozzle instructions in the Operation section.
13 — ENG | D20249 |
