DeVillbiss Air Power Company D21684 warranty Operating Procedures contd High Pressure Operation

OPERATING PROCEDURES (cont'd)

High Pressure Operation:

DO NOT let hoses come in contact with very hot engine muffler during or immedi- ately after use of your pressure washer.

RISK OF INJECTION OR INJURY TO PERSON. DO NOT DIRECT DISCHARGE STREAM TOWARD PERSONS.

WHEN USING THE HIGH PRESSURE SETTING, DO NOT ALLOW THE JET-LIKE SPRAY TO COME IN CONTACT WITH UNPROTECTED SKIN, EYES, OR WITH ANY PETS OR ANIMALS. SERIOUS INJURY CAN OCCUR.

Multi-Reg — Pull back nozzle for high pressure— Figure 7.

Hi-Low — Turn knob clockwise until it stops—Figure 8.

Dual Lance — Turn black handle grip clockwise until it stops—Figure 9.

NOTE: O°, 15°, 25°, and 40° nozzles will change the fan spray. The size of the nozzle will determine the size of the fan spray. To change nozzles:

1.Shut off the pressure washer and turn off the water supply.

2.Pull trigger on gun handle to relieve any water pressure.

3.Remove the nozzle on the end of the wand.

4.Insert new nozzle and tighten securely. Note: Be sure to teflon tape nozzle prior to assembly. Maintain at least one thread away from the end when applying the tape. You must wrap teflon tape in the direction of the threads. Two wraps only required.

Multi-Reg (High Pressure Setting)

Figure 7

Hi-Low

Figure 8

Dual Lance

Figure 9

11 — ENG