DeVillbiss Air Power Company D21684 warranty Operating Procedures, Start-Up, Illustration C

5.		Some pumps are shipped from the
		factory with a red shipping plug. Refer
		to page 16 and 17 to identify your pump.
		The Annovi Reverberi pump can also be
		identified by its name printed on top of
	the pump. The shipping plug prevents any oil from
	leaking out of the pump in shipping. Attached to the
	shipping plug is a plastic bag which contains the
	new oil plug. The shipping plug must be removed
	and the new oil plug installed before the pressure
	washer is operated-see illustration C. To remove
			Illustration C
	the shipping plug, turn counterclockwise and dis-
	card. Remove the new oil plug from the plastic bag
	and insert into the pump. Tighten securely.

OPERATING PROCEDURES

ATTENTION: Become familiar with the operating procedures before starting your unit.

Start-Up

1.Add fresh high quality unleaded gasoline—Figure 1.

2.Check engine oil level. See Engine Operator's Manual for correct amount and type.

NOTE: Some engines are equipped with a low oil sensor and the correct amount of oil must be added or the engine will not start.

3.Check pump oil level (if applicable–See Mainte- nance Section.)

4.Connect high pressure hose to pump outlet — Figure 2 for threaded hoses. Figure 3 for hose with quick connects.

Never pull water supply hose to move pressure washer. This could damage hose and/or pump inlet.

Add Gas

Figure 1

Twist Connect

Figure 2

OR

Quick Connect

OPERATION

Figure 3

9 — ENG