DeVillbiss Air Power Company NF2502X4, NBSNC2X4, SNC1002X4 Regulator Air Flow Oiler Filter

Figure 3

Regulator

Air Flow

Oiler

Filter

NOTE

Excessive oil will damage o-rings and seal of tool. If in-line oiler is used, manual lubrication through the air inlet is not required on a daily basis.

Do not use any type of flammable gases or oxygen as a power source for the tool. Use filtered, lubricated, regulated com- pressed air only. Use of compressed gas instead of compressed air may cause the tool to explode and cause death or serious personal injury.

Do not use a check valve or any other fittings which will allow air to remain in the tool. Serious personal injury or prop- erty damage could occur.

Use a Pressure Regulator on your compressor with an operating pressure of 0-125 PSI. A Pressure Regulator is required to control the operating pres- sure of your tool. Refer to the label on your nailer/stapler for the maximum P.S.I.

Always connect the Female Quick Cou- pler to the air hose. Never connect the Female Quick Coupler to the tool.

Never carry the tool by the hose or pull the hose to move the tool or a com- pressor. Keep hoses away from heat, oil, and sharp edges. Replace any damaged, weak or worn hoses.

The air compressor must be able to maintain a minimum of 65 PSI when the tool is being used. An inadequate air supply can cause a loss of power or inconsistent operation.

NOTE

For better performance, install a 3/8"

Quick Connector (1/4" NPT threads) with an inside diameter of .315 (8 mm) on your Tool and a 3/8" Quick Coupler on the air hose. A minimum of 3/8" I.D. air hose with a rated working pressure of 150 PSI or above should be used.

PAGE 8