English
USE SPLASH GUARD FOR EVERY OPERATION FOR WHICH IT CAN BE USED. REPLACE DAMAGED CUTTING WHEEL BEFORE OPERATING.
DO NOT EXPOSE TO RAIN OR USE IN DAMP LOCATIONS.
NEVER USE PAN HEATER OR OTHER HEATER SOURCE FOR HEATING WATER. DAMAGE TO THE TOOL, FIRE OR PERSONAL INJURY COULD RESULT.
THINK! YOU CAN PREVENT ACCIDENTS.
ON CUTTING WHEEL COVER
CAUTION: PROPERLY SECURE COVER WITH BOTH SCREWS BEFORE USE.
ON CART
WARNING: TO REDUCE THE RISK OF INJURY, ALWAYS VERIFY THE CUTTING WHEEL IS ADJUSTED TO THE CORRECT HEIGHT AND LOCATION IN THE CENTER OF THE CART GROOVE BEFORE OPERATING SAW.
Quick Start Guide
D24000 Wet Tile Saw
WARNING: For your own safety, read the instruction manual before operating the wet tile saw. Failure to heed these warnings may result in personal injury and serious damage to the saw. When servicing this tool, use only identical replace- ment parts. Have damaged cords replaced by an authorized service center.
FIG. 1
The motor arm assembly comes assembled. Open the box and lift the assembly out, as shown in Figure 1.
Step 1
1.Install the motor arm onto frame assembly. Using the wrench supplied, install and tighten the two screws closest to the rail first. Install and tighten the other two screws.
Step 2
2.Attach the cutting wheel.
a.Using the smaller Allen wrench supplied, loosen (do not remove) the screw on the side of the cutting wheel cover. Pull the rub- ber side flap back and lift the cover toward the rear of the saw.
b.Press spindle lock button. Remove the cut- ting wheel nut with hex wrench provided. Remove outer flange.
c.Install the cutting wheel with the rotational arrow facing the same way as on the rota- tional arrow on the cutting wheel cover. Press the spindle lock button while tighten- ing the cutting wheel nut.
d.Replace cover and tighten screw.
For further details, refer to
To Attach Cutting Wheel
in the
Instruction Manual.
4
