Step 3
3. Attach the cutting cart to the rails.
For further details, refer to
Assembly in the
Instruction Manual.
NOTE: Make sure the cart lock is in full open position.
a. Align the arrow on the rear of the cutting cart with the round rail on the frame of the saw.
b. Place the rear roller assembly onto the round rail.
Step 4
4.The outer rim of the cutting wheel should always be at least 3/16" (5mm) below the cart surface. Push cart entirely through the cutting wheel before cutting to be sure that the cutting wheel depth is properly adjusted to avoid cutting the cart. Adjust the depth of cut knob (BB) and tighten the locking wing nut (MM), then the head lock knob
(D).
For further details, refer
to Adjustments in
the Instruction Manual.
|
|
|
|
|
| 3/16" (5MM) | English |
|
|
|
|
|
| ||
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
BB
D
MM 
c. Slide the cutting cart assembly onto the rail system. Tilt the front of the cart upward slightly to clear the cart stop.
Steps 5, 6, 7, 8
5.Place the saw in the water pan. The water pan drain hole should be in the front position.
6.Attach the water pump to the water line and insert pump power cord into the socket. Position pump properly in pan, as shown.
7.Fill the pan with 5 gallons of water. The pump should be sub- merged.
NOTE: For longer pump life, always place the pump in a clean water source.
8.Turn saw on. If lower water flow is desired, use the flow restrictor on the water line.
5
