| Troubleshooting Guide… |
|
|
| ||
| TROUBLE! TOOL VIBRATES EXCESSIVELY DURING CUT |
|
|
| ||
| WHAT’S WRONG? | WHAT TO DO… |
| |||
1. | Tool not mounted securely to stand or work bench. | 1. | Tighten all mounting hardware. See page 8, Procedure for |
| ||
|
|
|
|
| Permanent Mounting. |
|
2. | Damaged wheel. | 2. | Replace wheel. |
| ||
3. | Workpiece not clamped properly. | 3. | Refer to Material Clamping and Supporting page 6. |
| ||
| TROUBLE! DOES NOT MAKE ACCURATE CUTS |
|
|
| ||
| WHAT’S WRONG? | WHAT TO DO… |
| |||
1. | Fence not adjusted correctly. | 1. | Check and adjust. See Fence Operation on page 6. |
| ||
2. | Wheel is not square to fence. | 2. | Check and adjust. |
| ||
3. | Excessive force used to make cut. | 3. | Reduce cutting force, let the wheel do the work. |
| ||
4. | Work piece moving. | 4. | Clamp workpiece securely. See Material Clamping and |
| ||
|
|
|
|
| Supporting, page 6. Make sure material is laying flat against the |
|
|
|
|
|
| base. |
|
TROUBLE! CANNOT MOVE ARM |
|
|
| |||
WHAT’S WRONG? | WHAT TO DO… |
| ||||
1. | Lock down pin is engaged. | 1. | Push down slightly on the arm, pull down lock down pin and |
| ||
|
|
|
|
| raise arm. |
|
TROUBLE! MATERIAL MOVES DURING CUT |
|
|
| |||
WHAT’S WRONG? | WHAT TO DO… |
| ||||
1. | Fence slipping or workpiece incorrectly placed or clamped. | 1. | See Material Clamping and Supporting, page 6. |
| ||
2. | Vise too loose | 2. | Tighten vise clamping. |
| ||
3. | Excessive cutting force. | 3. | Reduce cutting force. |
| ||
|
|
|
|
|
|
|
English
10
