English
CAUTION: Wear appropriate hearing protection during use. Under some conditions and duration of use, noise from this product may contribute to hearing loss.
CAUTION: Spark deflector will get hot. Avoid touching or adjusting while hot. Keep cordset and materials away from spark deflector.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemi- cals known to the State of California to cause cancer, birth defects, or other reproductive harm. Some examples of these chemicals are:
•lead from
•crystalline silica from bricks and cement and other masonry products, and
•arsenic and chromium from
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.
•Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other construction activities. Wear protective clothing and wash exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may promote absorption of harmful chemicals.
WARNING: Always use NIOSH/OSHA approved respiratory protection appropriate for the dust exposure. Direct particles away from face and body.
For your convenience and safety, the following warnings are on your
FOR SAFE OPERATION READ THE INSTRUCTION MANUAL.
DO NOT USE TOOTHED BLADES.
USE ONLY REINFORCED WHEELS RATED 4100 RPM OR HIGHER.
WHEN SERVICING USE ONLY IDENTICAL REPLACEMENT PARTS.
ALWAYS: WEAR EYE PROTECTION, USE GUARDS, CLAMP WORKINVISE,USEPROPERRESPIRATORY PROTECTION. DO NOT EXPOSE TO RAIN OR USE IN
DAMP LOCATIONS.
ONLY USE CHOP SAW WHEEL OF A MAX. THICKNESS OF 3.1 mm AND A MAX. DIAMETER OF 355 mm.
FEATURES (Fig. 1, 4)
A. Lock pin | J. Wheel |
B. Spark deflector screw | K. Guard |
C. Spark deflector | L. Wheel lock lever |
D. Base | M. Depth stop bolt |
E. Fence | N. Trigger switch |
F. Vise | O. Padlock hole |
G. 8 mm hex wrench | P. Jam nut |
H. Crank | Q. Fence bolts |
I. Vise lever |
|
Power Supply
Be sure your power supply agrees with the nameplate marking.
A voltage decrease of more than 10% will cause a loss of power and overheating.
Cutting Capacity
The wide vise opening and high pivot point provide cutting capacity for many large pieces. Use the cutting capacity chart to determine total maximum size of cuts that can be made with a new wheel.
3