DeWalt D28700 Standard Equipment, To Carry Fig, Unlocking Fig, Spark Deflector Adjustment Fig

MAXIMUM CUTTING CAPACITY

NOTE: Capacity shown on chart assumes no wheel wear and optimum fence position.

Workpiece Shape:
			A x B
90º Cutting Angle	A = 4.5"	A = 4-11/16"	4-1/2" x	5-1/8"	A = 5-3/8"
	(115 mm)	(115 mm)	(119 mm x	130 mm)	(137 mm)
			4" x 7-5/8"
			(102 mm x	194 mm)
			3" x 9"
			(76 mm x 229 mm)
45º Cutting	A = 3-13/16"	A = 3-13/16"	4-1/2" x 3-13/16"		A = 3-13/16"
Angle	(98 mm)	(98 mm)	(115 mm x 98 mm)		(98 mm)

English

CAUTION: CERTAIN LARGE, CIRCULAR OR IRREGULARLY SHAPED OBJECTS MAY REQUIRE ADDITIONAL HOLDING MEANS IF THEY CANNOT BE HELD SECURELY IN VISE.

CAUTION: DO NOT CUT MAGNESIUM WITH THIS TOOL.

Standard Equipment

114" (455 mm) Metal Cutting Abrasive Wheel

1Wheel Wrench

1Instruction manual

To Carry (Fig. 1)

Fold down unit to position where you can carry the saw. Push in lock pin (A) to lock arm down.

Unlocking (Fig. 1)

To unlock tool and raise head, depress motor arm slightly and pull lock pin (A) out. Motor arm will then pivot upward.

Spark Deflector Adjustment (Fig. 1)

To best deflect sparks away from surrounding persons and materials, loosen the screw (B), adjust the spark deflector (C) and then retighten screw. Do not allow cordset to come into contact with deflector or sparks as damage to cordset may occur.

Depth Stop (Fig. 1)

Depth stop is set at the factory for a new 14" (455 mm) wheel to prevent wheel from cutting into the supporting surface. To allow more depth of cut, use the 8 mm hex wrench provided (G) to loosen the depth stop bolt (M) and raise bolt to desired height and then turn jam nut (P) clockwise until seated firmly on the casting. Securely tighten the depth stop bolt before use.

CAUTION: When changing to a new wheel, readjust depth stop to original position to prevent cutting into supporting surface.

4