THE LASER IS PROJECTING 2 LASER LINES WHEN THE LASER HEAD IS ROTATED.
Take the laser to a DEWALT service center for calibration.
English | THE POWER LED LIGHT IS FLASHING, THE ROTARY HEAD |
| |
| HAS STOPPED SPINNING AND THE LASER DIODES HAVE |
| SHUT DOWN. |
| This indicates that the batteries need to be replaced. TIP: See |
| “Installing Batteries” section. |
| THE BUMP SENSOR WARNING LED LIGHT IS FLASHING. |
| See “Bump Sensor” section for operating instructions. |
| THE BUMP SENSOR WILL NOT TURN THE LASER OFF AFTER |
| THE TOOL HAS GONE OUT OF LEVEL. |
| The Bump Sensor is NOT AN OUT OF LEVEL SENSOR. See “Bump |
| Sensor” section. |
| THE ROTATING LASER BEAM IS DIFFICULT TO SEE INDOORS. |
| Ambient light conditions will influence the visibility of the laser beam. |
| To aid in beam visibility, adjust the rotation speed using the ON/OFF |
| VARIABLE SPEED SWITCH. Remember: Slow Speed = Bright Line; |
| Fast Speed = Solid Line. Wearing the Laser Enhancement Glasses |
| can also help you see the beam better. |
| I NEED TO ADJUST THE LASER FOR A VERTICAL / PLUMB |
| ORIENTATION. |
| See “Mounting on a Tripod,” “Floor Mount” and “Wall Mount” sections. |
| I NEED TO ADJUST THE LASER FOR MOUNTING ON A WALL. |
| See “Wall Mount” section. |
THE LASER ROCKS WHEN POSITIONED ON THE FLOOR.
The laser is designed to sit on 3 built in contact points. If the laser rocks, try placing it on a more level surface or on a a tripod.
I NEED TO STOP THE ROTARY HEAD ROTATION TO DIRECT THE LASER DOT ONTO A MARK OR TO SET A MARK.
See “Manual Head Rotation” section.
THE BUBBLE(S) IN THE VIAL(S) WILL NOT MOVE WHEN ATTEMPTING TO LEVEL THE LASER.
The tool must be positioned on a relatively smooth and level surface before being leveled. The laser cannot be leveled if the tool is set up outside of its leveling range. Roughly level the tool before attempting to level the laser with the leveling knobs.
I CAN ONLY ADJUST THE BUBBLE IN THE PLUMB VIAL WHEN ATTEMPTING TO PROJECT A VERTICAL LASER LINE.
See “Vertical Plumbing” section for instructions on projecting a vertical laser line.
COLD STORAGE INFORMATION
After storing this product in extremely cold conditions, the laser head may not immediately rotate when turned on. The rotary head may be started by depressing and turning the Manual Rotation Button counter- clockwise.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
12
