English
•Your DEWALT laser is equipped with 2, side by side laser diodes which produce an extremely bright, visible beam when the laser head is rotated.
•Always mark the center of the laser line or dot.
•To increase working distance and accuracy, set up the laser in the middle of your working area.
•When attaching to a tripod or wall, mount the laser securely.
•When working indoor a slow rotary head speed will produce a visibly brighter line, a faster rotary head speed will produce a visi- bly solid line.
•To increase beam visibility, wear the Laser Enhancement Glasses provided and/or use the Laser Target Card to help find the beam.
•To transfer a laser dot mark use the Manual Rotation Button on the top of the laser head for quick and easy control. See “Manual Head Rotation Button” section for instructions.
•Extreme temperature changes can cause movement of internal parts that can effect accuracy. Check your accuracy often while working.
•When working with the DEWALT Digital Laser Detector set the laser variable speed control to the fastest setting.
•Utilize the Bump Sensor feature on the laser to warn you if the tool has been bumped after set up.
•If the laser has been dropped or has tipped over while set up on a tripod, have the calibration system checked by a qualified service center before continuing use.
Installing Batteries
This tool is powered by 3 “D” batteries. To install the batteries provid- ed, remove the battery compartment cover by loosening the thumb- screw at the top of the cover. Insert the batteries as indicated by the diagram molded into the battery compartment and replace the battery cover.
WARNING: Batteries can explode, or leak, and can cause injury or fire. To reduce this risk:
•Carefully follow all instructions and warnings on the battery label and package.
•Always insert batteries correctly with regard to polarity (+ and
•Do not short battery terminals.
•Do not charge batteries.
•Do not mix old and new batteries. Replace all of them at the same time with new batteries of the same brand and type.
•Remove dead batteries immediately and dispose of per local codes.
•Do not dispose of batteries in fire.
•Keep batteries out of reach of children.
•Remove batteries if the device will not be used for several months.
Control Panel
The Control Panel contains the ON/OFF/VARIABLE SPEED SWITCH, ON/LOW BATTERY INDICATOR LED LIGHT, and BUMP SENSOR CONTROL BUTTONS AND LED INDICATOR LIGHTS.
To Turn the Laser On:
Insert fresh batteries into the tool.
Rotate the ON/OFF knob (A) clockwise to power the laser ON. The dual laser diodes will turn on and the POWER LED (B) Light will illu- minate. The rotary head will remain stationary during the first 1/4 turn of the knob. Rotation of the laser head will begin as the Variable
A | B C D E |
F
2
