DeWalt DWE6401DS Additional Safety Rules for Paint Removal, Personal Safety, Environmental Safety

English

Hz			hertz	W			watts
min			minutes			.......	alternating current
			direct current				alternating or direct
		........				.......
			Class I Construction	n............o			current
	.............
.................			(grounded)				no load speed
			Class II Construction				earthing terminal
	.............				........
.................			(double insulated)		.........		safety alert symbol
…/min			per minute	BPM....			beats per minute
RPM			revolutions per minute	IPM			impacts per minute
sfpm			surface feet per minute

Additional Safety Rules for Paint Removal

1.Sanding of lead based paint is NOT RECOMMENDED due to the difficulty of controlling the contaminated dust. The greatest danger of lead poisoning is to children and pregnant women.

2.Since it is difficult to identify whether or not a paint contains lead without a chemical analysis, we recommend the following precautions when sanding any paint:

PERSONAL SAFETY

1.No children or pregnant women should enter the work area where the paint sanding is being done until all clean up is completed.

2.A dust mask or respirator should be worn by all persons entering the work area. The filter should be replaced daily or whenever the wearer has difficulty breathing. See your local hardware store for the proper NIOSH approved dust mask.

3.NO EATING, DRINKING or SMOKING should be done in the work area to prevent ingesting contaminated paint particles. Workers should wash and clean up BEFORE eating, drinking or smoking. Articles of food, drink, or smoking should not be left in the work area where dust would settle on them.

6

ENVIRONMENTAL SAFETY

1.Paint should be removed in such a manner as to minimize the amount of dust generated.

2.Areas where paint removal is occurring should be sealed with plastic sheeting of 4 mil thickness.

3.Sanding should be done in a manner to reduce tracking of paint dust outside the work area.

CLEANING AND DISPOSAL

1.All surfaces in the work area should be vacuumed and thoroughly cleaned daily for the duration of the sanding project. Vacuum filter bags should be changed frequently.

2.Plastic drop cloths should be gathered up and disposed of along with any dust chips or other removal debris. They should be placed in sealed refuse receptacles and disposed of through regular trash pick-up procedures. During clean up, children and pregnant women should be kept away from the immediate work area.

3.All toys, washable furniture and utensils used by children should be washed thoroughly before being used again.

SAVE THESE INSTRUCTIONS

FOR FUTURE USE

Motor

Be sure your power supply agrees with the nameplate marking. Voltage decrease of more than 10% will cause loss of power and overheating. DEWALT tools are factory tested; if this tool does not operate, check power supply.